Product Description Futaba 12Z 2.4GHz R6014FS Heli Mode 1

Brand New

 FUTK9303

This is the FASST 2.4GHz Futaba 12ZHP Computer Radio on Mode 1 with the R6014FS Synthesized 14-Channel Receiver.

This is the helicopter version which will default to heli settings when powered up and does not have a ratcheted throttle stick.

If your transmitter's region code is something other than the United States,the TM-14 Module sold in the United States is not compatible with this
transmitter. As such, it is necessary to purchase the TM-14 module which matches the region code of the transmitter.

The Futaba 12ZHP shares many features with the 14MZ such as Dual Internal Processors, Real-Time Response with 2048PCM,
Fully Synthesized Receiver, Servo Grouping, Variable Dual Rates and Quad-Bearing Gimbals

FASST Features
Futaba's FASST (Futaba Advanced Spread Spectrum Technology) shifts very quickly virtually eliminating signal conficts and
interruptions unlike other 2.4GHz systems that only stay on one or two frequencies
Dual antenna diversity enables FASST system to automatically and seamlessly select the best reception between the two antennas
built into the receiver ensuring that the aircraft stays under
constant control of transmitter regardless of altitude
Pre-Vision Packet Screening technology scans incoming data for potential problems and applies sophisticated error correction
techniques for solid impenetrable link with model
Easy Link system features a unique ID code in the transmitter that links to the receiver insuring that receiver only follows commands
from this transmitter-with over 134 million possible codes there is no chance for a conflict
No hassle Fail Safe programmed through transmitter-no complicated set-up steps or binding plugs
When performing a ground check, the Power Down function allows
modeler to reduce power from up to 50+ paces away-like
retracting the antenna on a conventional transmitter
Purpose built custom IC chips for key functions; no off-the-shelf IC
chips

General Features
Dial-N-Key jog dial with joy stick button allows cursor movement in four directions for very user friendly programming
PCM G3 2048 resolution is "backwards compatible" with 1024 PCM, and FM/PPM
Supports 13 different wing types, 3 tail types and 3 motor types
Supports eight flight conditions (seven plus the default)
Stores memory for up to twenty-five models
245 model memory available with optional 32MB Compact Flash Card available separately, (FUTM9410)
Six factory-set Variable Dual Rate (VDR) curves can be assigned to any function in any flight condition configuration
Variable Dual Rates (VDR) and Expo can be combined so they are automatically activated when a function is activated, no program
mixing required.
Dual Internal Processors allow one processor to be devoted to flying functions while the other processor focuses on non-flight
functions such as input and communications
7.4V 2200mAh Lithium Ion transmitter battery (FUTM1475) for long operating times
R6014FS Receiver;
Retains G3 2048 resolution and Futaba Real Time Response from the 72MHz version.
Simple one-touch binding - no plugs to mess with or lose
A full range system for all aircraft from giant scale to Park Flyer applications-no need to buy separate receiver for
specific aircraft Dual Antenna Diversity allows 2.4GHz FASST Futaba transmitter to
select the best reception between the two receiver antennas with no signal loss
Rubber grommets installed where antennas exit to eliminate stress and fraying of the two antenna wires
Servo Grouping; Multiple servos controlling a single function can be set up through the transmitter and then plugged into differently
Zdjustable receiver channels (even non-consecutively) without needing a separate servo synchronizer for mixing.
Quad-Bearing Gimbals for smoothest motion and response, stick tension and detent are adjustable
Seven color LED indicator